Surveillance Port Details
Use this screen to view detailed information about a port on the Surveillance screen.
Go to Switch > Monitor > Surveillance and click on a value in the Discovered Devices column to access this screen.
Switch > Monitor > Surveillance > Port Details
The following table describes the labels in this screen.
Label | Description |
|---|---|
Status | |
Link speed | This shows the speed (either 10M for 10 Mbps, 100M for 100 Mbps, or 1G for 1 Gbps) and the duplex (F for full duplex or H for half). This field displays Down if the port is not connected to any device. |
PoE draw | This shows the total power that the connected PD draws from the port, in watts. This allows you to plan and use within the power budget of the Nebula Device. |
PD health | This shows the status of auto PD recovery on this port. • Red: The Nebula Device failed to get information from the PD connected to the port using LLDP, or the connected PD did not respond to the Nebula Device’s ping requests. • Yellow: The Nebula Device is restarting the connected PD by turning the power off and turning it on again. • Green: The Nebula Device successfully discovered the connected PD using LLDP or ping. • --: Auto PD Recovery is not enabled on the Nebula Device and/or the port, or the Nebula Device is not supplying power to the connected PD. For details on configuring auto PD recovery on a port, see Switch Ports. |
Extended range | This shows whether extended range is enabled on the port. |
Bandwidth Tx/Rx (%) | Tx shows the number of kilobytes per second transmitted on this port. Rx shows the number of kilobytes per second received on this port. |
CRC | This shows the number of packets received with CRC (Cyclic Redundant Check) errors. |
Power cycle | Click Reset to power off the PD connected to the port, by temporarily disabling then re-enabling PoE. |
Neighbor detail | This section shows all clients connected to the port. |
Search clients | Search for one or more clients in the list by keyword, status, system name, port, IP address, or firmware version. |
clients | This shows the number of clients connected to this port. |
Flush | Click this to remove all offline clients from the list. |
Status | This shows whether the client is online (green) or offline (red), and whether the client is wired or wireless. |
System name | This displays the system name of the Nebula Device. |
Port | This displays the number of the Nebula Device port that is connected to the Nebula Device. |
IP | This shows the IP address of the Nebula Device. |
Firmware | This shows the firmware version currently installed on the Nebula Device. |
Description | This shows the descriptive name of the Nebula Device. |