Troubleshooting
This offers some suggestions to solve problems you might encounter. The potential problems are divided into the following categories.
Power, Hardware Connections, and LEDs
The PoE12-3PD does not turn on. None of the LEDs turn on.
1 Check that the PoE switch or PoE injector connected to the UPLINK port is a PoE device.
2 Ensure the the Ethernet cable is connected to the UPLINK port and that you're using the supported Ethernet cable. See PoE Standards for supported cables.
3 Check that the LEDs are behaving correctly. See LED Descriptions.
4 If the problem continues, contact the vendor.
One of the LEDs does not behave as expected.
1 Make sure you understand the normal behavior of the LED. See LEDs.
2 Check the hardware connections. See Port Connections.
3 Inspect your cables for damage. Contact the vendor to replace any damaged cables.
4 Disconnect and re-connect the power adapter or cord to the PoE12-3PD.
5 If the problem continues, contact the vendor.
The Link LED does not light up when a device is connected.
• Verify that the attached device(s) is turned on and properly connected to your PoE12-3PD.
• Make sure the network adapters are working on the attached devices.
• Verify that proper network cable type is used and its length does not exceed 100 meters.
The LEDs of port 1-3 are off and/or power is not being supplied to my Powered Device (PD).
• Ensure to connect the PD to port 1, 2 or 3 of your PoE12-3PD.
• Check your PoE12-3PD’s PoE MAX LED. If it blinks quickly in yellow or is off, the remaining power budget of the PoE12-3PD is relatively low, and the connected PDs might not have enough power to function properly. See LEDs for more information on LEDs.
• Ensure the UPLINK port of the PoE12-3PD is properly connected to a powered PoE Switch or PoE injector. Verify that the power source of the PoE Switch or PoE injector is on and working.
• Ensure all the Ethernet cables are properly connected and that you are using the supported Ethernet cable. See PoE Standards for supported cables. Contact your local distributor if the problem persists.
Improper Network Cabling and Topology
Improper network cabling or topology setup is a common cause of poor network performance or even network failure.
Troubleshooting Improper Network Cabling and Topology 
problem
corrective action
Faulty cables
Using faulty network cables may affect data rates and have an impact on your network performance. Replace with new standard network cables.
Non-standard network cables
Non-standard cables may increase the number of network collisions and cause other network problems that affect your network performance.
For 1G connections, use Cat5e cable for better speed.
Cabling Length
If you use longer cables than are needed, transmission quality may be affected.
The network cables should not be longer than the limit of 100 meters.
Too many hubs between the computers in the network
Too many hubs (or repeaters) between the connected computers in the network may increase the number of network collision or other network problems. Remove unnecessary hubs from the network.
A loop in the data path
A data path loop forms when there is more than one path or route between two networked computers. This results in broadcast storms that will severely affect your network performance. Make sure there are no loops in your network topology.